You have no items in your shopping cart.
- Shop Top Devices
- Shop Screen Protection
- Shop Protective Skins
- Shop Cases
- Shop Extras
- PRO TIP 1 -
Before you begin installation, make sure the device screen is completely dust-free. Dust, hair and other small particles can cause a permanent bubble under the protector. Use the included microfiber cleaning cloth and dust removal strips to remove any dust before installation.
- PRO TIP 2 -
When using the application gel, use enough to cover the entire adhesive side of the protector. This will give you the ability to slide the protector into position. It may also help to let the gel dry for 30 minutes before removing the cap sheet.
iPhone 6/6s and 6/6s Plus install
Hi Im Nick and today I am gonna teach you how to install your iPhone 6 & 6 Plus UltraTough Clear Skins.
Here is what comes inside the packaging:
• Application instructions
• Back film
• front film
• a BodyGuardz Squeege
• a BodyGuardz Sticker
• Application gel
• microfiber cleaning cloth
• and a layout diagram
Lets get started. Be sure to wipe down your screen with the provided microfiber cleaning cloth. If you want you can clean your fingers with the application gel. Next peel back the protector from the liner. Apply 5-8 dots of application gel, and then rub it around the adhesive part of the screen protector until it is completely covered. Now line up the screen protector using the speaker and home button as your guide. (because of the gel you can move the protector around on your screen till it looks good.) Next use the squeegee card and microfiber cleaning cloth to push out all the application gel.
Flip the phone over and lets do the back. Peel the protector from the liner like you did with the first protector. Again apply 5-8 dots of application gel, and then rub it around the adhesive side of the screen protector until it is completely covered. This time use the camera as your guide. If you don't like where you have placed your protector you can always lift it up and re-apply it. Use the micro-fiber cleaning cloth and squeegee to push out the gel. The sides may not immediately adhere after the install. Wait up to 30 minutes to apply the sides to your phone.
Congratulations on your Clear Skins Installation, Not only does your phone look good but is now scratch protected.